Draft:Hall Switch


A Hall Switch is an electrical engineering concept which solves the problem of controlling lights in a room from two separate switches. In any room with more than one door, for example a hall or corridor, a person travelling through will want to turn the lights on at one place and turn them off at another, with the possibility of either retracing their steps or being followed by a second person going in the same direction. Thus the need exists to be able to toggle the lights at any time from their current state (eg on) to the opposite (eg off) from either switch at any time.

This is achievable through several strategies, three of which are often found in domestic settings, each of which relies on a pair of SPDT switches to control the path from Live to Neutral, via the light fittings. SPDT stands for "Single Pull, Double Throw" meaning the switch has two states, connecting a Common pole to either one of two other poles. An SPDT switch is never open-circuit, except momentarily while changing state, and while it may be used as an open/close SPST switch by not connecting the third pole the Hall Switch setup makes use use of the ability to carry current through either pole.

Three wires between switches

A simple setup runs Live, Neutral and a third wire between the switches, with the bulbs on the Live rail. Whenever either switch is toggled, the route to Neutral is either completed or broken and the lights change state.

Two wires between switches

In this configuration two wires are connected only to the switches and when both are connected to the same wire the path to Neutral is completed.

One wire between switches

A variation on the three-wire solution supplies power from either end rather than down the middle.

No wire between switches

In this arrangement power is supplied to both switches independently and a single common rail carries power only if the switches are connected to opposite poles, and carries nothing when the switches are connected to the same pole.

  • Three wires between
    Three wires between
  • Two wires between
    Two wires between
  • One wire between
    One wire between
  • No wires between
    No wires between

The exact physical path the wires take is of course not important. The wires "between" the switches might easily follow run along the same route as the wires that connect to the light fittings. It is often impossible to understand which strategy has been employed in an existing installation without careful investigation with a multimeter.

References

Content Disclaimer

Informasi ini disarikan dari Wikipedia dan disajikan kembali untuk tujuan edukasi. Konten tersedia di bawah lisensi CC BY-SA 3.0. Kami tidak bertanggung jawab atas ketidakakuratan data yang bersumber dari kontribusi publik tersebut.

  1. The information displayed on this website is sourced in part or in whole from Wikipedia and has been adapted for the purpose of restating it. We strive to provide accurate and relevant information, however:
  2. There is no guarantee of absolute accuracy. Wikipedia is an open, collaborative project that can be edited by anyone, so information is subject to change.
  3. It is not intended to constitute professional advice. The content displayed is for informational and educational purposes only. For important decisions (e.g., medical, legal, or financial), please consult a professional.
  4. Content copyright. Wikipedia is licensed under the Creative Commons Attribution-ShareAlike License (CC BY-SA). This means that content may be reused with appropriate attribution and shared under a similar license.
  5. Responsible use. Any risk arising from the use of information from this website is entirely the responsibility of the user.