This  level-5 vital article is rated Start-class on Wikipedia's content assessment scale. It is of interest to the following WikiProjects:

Metalworking (inactive) This article is within the scope of WikiProject Metalworking, a project which is currently considered to be inactive.MetalworkingWikipedia:WikiProject MetalworkingTemplate:WikiProject MetalworkingMetalworking Textile arts Low‑importance This article is within the scope of WikiProject Textile arts, a collaborative effort to improve the coverage of textile arts on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.Textile artsWikipedia:WikiProject Textile artsTemplate:WikiProject Textile artsTextile arts Low This article has been rated as Low-importance on the importance scale.

Should this be replaced by a disambiguation? Also, I am reasonably certain that mesh networks predate meshes for 3D modelling, although they may not predate meshes for 2D finite element analysis. Kelly Martin 15:43, September 8, 2005 (UTC)

Isn't this more of a dictionary definition and not an encyclopedia entry? --NicholasCharlesCaruso 01:08, 10 October 2005 (UTC)[reply]

This page needed to be reverted. Apparently someone thought it was a sandbox Shahar Goldin 19:05, 4 December 2006 (UTC)[reply]

What happened to mesh as in a measurement of fineness in chemistry? 67.42.75.190 22:37, 5 February 2007 (UTC)[reply]

Would it be possible to have some information about the techniques used for producing mesh on this page? I suppose I am agreeing with NicholasCharlesCaruso above that this article is more of a dictionary definition Cjashwell (talk) 15:57, 22 February 2012 (UTC)[reply]

See also: MESH mesh.eu ISP, Colocation, IP-Transit, ... —Preceding unsigned comment added by 213.203.192.254 (talk) 11:53, 7 December 2009 (UTC)[reply]

(Perhaps as an explanation of 'See also:' above:) "Mesh" is also a flexible/expandable amateur radio communications protocol, that has been around for at least 7 years, and probably many more, during amateur development.
108.18.219.150 (talk) 21:50, 6 October 2020 (UTC)[reply]

Perhaps we should note the emerging sophistication of radio meshes: as the number of users (and their devices) being served by each 802.11 router increases, traditional routers delivered less-reliable transmissions to end points. Widely-available and inexpensive multiplexing ASICs, pinholes, and software have enabled creation of multiple sub-channels and distribution of those sub-channels across each radio frequency. The resulting network is a mesh, although it's created by software engineering rather than electromagnetic engineering. DanvilleDad (talk) 21:27, 28 April 2025 (UTC)[reply]